SX1 BLBNE, PREHRATIE WINSUPU NEPOMOHLO, STALE VYBITA BATERIA

[prihlaseny]

nerozumiem testpointu sx1, treba tam rezat, alebo spijit odpor, vypocitat kody ako u x65, alebo ako? chcem to izivit v JOKEROVI, je tu aj FF pre joker, tak prosim o radu, ci ten testpoint treba spojit, a drzat, alebo rezat, alebo ako, mam mrtvu sx1, co bzuci, winsup nahraje, ale nezabera

[prihlaseny]

v servisnom rezime v Jokerovi pise:
Start...
Loading ServiceBoot...
Sending ServiceBoot Ok.
BFB Speed 115200 Baud - Ok.
HWID: 194 (SX1)
SX1 lg44 Sw15 07.10.04 11:11:57
IMEI: 352079001391547
DisplayID: 0, Unknown or misses
Code(05): OTP closed
Code(0A): BootKEY misses in EEPROM
Code(0D): Keys are registered in BCORE
Code(10): Minimal access to BFB
Code(15): Complete condition
Code(19): Monitoring is switched on
Code(1D): Blocks 5121,5122,5123 are present
Battery Voltage very low! 2205 mV!
SecurityMode: Customer

info:
Get Info...
HWID: 194 (SX1)
SX1 lg44 Sw15 07.10.04 11:11:57
IMEI: 352079001391547
DisplayID: 0, Unknown or misses
Code(05): OTP closed
Code(0A): BootKEY misses in EEPROM
Code(0D): Keys are registered in BCORE
Code(10): Minimal access to BFB
Code(15): Complete condition
Code(19): Monitoring is switched on
Code(1D): Blocks 5121,5122,5123 are present
Battery Voltage very low! 2206 mV!
SecurityMode: Customer
DSP Firmware Version 09, Power Asic Project ID: B3, RF Chipset ID: 05
EELITE Info: free buffer 53632 bytes, free at all 55622 bytes, free for deleted 55622 bytes.
EEFULL Info: free buffer 22524 bytes, free at all 35424 bytes, free for deleted 27376 bytes.
Battery Ri measurement: CutOff Idle: 3478mV, CutOff Talk: 3528mV, CutOff Idle: 3366mV, CutOff Talk: 3441mV, CutOff Idle: 3469mV, CutOff Talk: 3569mV, CutOff Idle: 3469mV, CutOff Talk: 3569mV.
Operating time: Total 9123777 sec, Current SW 9082175 sec.
Talk time: Total 243704 sec, Current SW 243704 sec.
CSD: Total 251595 bytes, Current SW 251595 bytes.
GPRS: Total 4294967295 bytes, Current SW 0 bytes.


KDE JE CHYBA, NIEKEDY SA ZAPNE, NABEHNE CELY TELEFON, BATERKU UIKAZE PLNU, HNED PRAZDNU, INOKEDY BZUCI, INOKEDY ZAPINAM LEN IDE ZVUCKA PRI TOTALNE VYBITEJ BATERKE, ANI DISPLEJ NESVIETI, PORADTE, TELEFON JE AKO NOVY, DOSKA NEPOSKODENA, PROSTE BABIKA JE, V POVODNOM STAVE, ANI RAZ NESPADOL

[prihlaseny]

ked dam na nabijacku, telefon zabzuci a nenabija

[dps]

Dával si tam patche? Jetstli si tam dával čistej FW a jeho nahrání proběhlo bez problémů, tak běž radši do servisu. S testpointem nic nedělej jestli máš na telefon ještě záruku. Možná můžeš zkusit zapnout telefon bez MMC (jestli nemáš patche)

[Mio]

Napeti baterie je polovicni nez ma byt, zkus ji nabit mimo telefon, navod najdes nekde tady v prispevcich. taky ocisti vnitrni i vnejsi kontakty baterie ..... . Baterie taky muze byt vadna.

Tespointy (jsou 3 moznosti) se u SX1 bud rezou (pokud je oznaceny spoj) nebo pres odpor uzemni (pokud je oznacen kontakt soucastky).

Jejich zobrazeni naleznes v Siemens Testpoint Station v sekci Utility

Joker funguje velmi podobne jako PapuaUtils, s testpointem se spojis a das vypocitat a pote zavest SKEY, pote muzes TP zrusit a mas telefon normalne pristupnej k flashovani odbloku atd..

[prihlaseny]

bateriu som nabil mimo telefon, ma 4,1 V , a telefon v jokerovi stale hlasi voltage very low 2469 V, som uz fakt zufali, je to uplne novy telefon, dovezeny, povodny stav, bateria cista kontakty, proste nic mechanicky neposkodene, moze to byt chybny symbian? telefon jak dam na nabijacku, tak sa rosviti, nabehne ikonka nabijania na 2 sekundy, telefon zabzuci a konec

[GgDag]

Mal som podobny problem ale akurat taky ze telefon nesiel vobec ale s jokerom fungoval a niekedy zabzucal ze je vybita bateria. Nepomohol ani TP teraz je uz 2 tyzdne v servise a stale nevedia co je s nim.

[prihlaseny]

ty si vistihol moj problem s tym bzucanim, spravil som TP, nahral FF cez jokera, telefon sa zapne, a stale bzuci, sem tam nabehnew, nenabija, prsote bude asi cely symbian poskodeny, ale ako ho dostat do telefonu? hm?

[prihlaseny]

PO OZIVENI CEZ JOKER SA TELEFON ZAPNE, NO VYPISE HLASKU: PRI ZAPNUTI SA VYSKYTLA CHYBA, KONTAKTUJTE PREDAJCU, A TELEFON SA VYPNE, CO S TYM? PREHRAT SYMBIAN?

[Sirus]

Tuto hlasku som pri mojich testoch s SX1 videl par krat a stacilo prehrat FW a bolo po probleme. Ale ci vyriesi aj ten tvoj, boh zna. Na TP a ozivovanie je na SM najvacsi kapo Krokodyl, upozornim ho na tento thread, snad pomoze.

[prihlaseny]

lenze tu hlasku mi vypise ked zalozim baterku z a50 siemensu, mam rozobraty, a len zo zadu na cistu dosku prilozim tu bateriu, a nabehne s tou hlaskou, o originalnou bateriou sx1 proste to nejde, nechapem
TP som spravil ten s odporom, joker nacital, tu je hlaska z neho po prehrati flashu:

tart...
Loading ServiceBoot...
Sending ServiceBoot Ok.
BFB Speed 115200 Baud - Ok.
HWID: 194 (SX1)
SX1 lg44 Sw12 23.04.04 08:59:17
IMEI: 352079001391547
DisplayID: 0, Unknown or misses
Code(05): OTP closed
Code(09): BootKEY is written in EEPROM
Code(0C): Keys miss in BCORE (CleanBCORE)
Code(10): Minimal access to BFB
Code(15): Complete condition
Code(1A): Block 76 is accessible
Code(1C): Block 5123 is not found
Battery Voltage very low! 2207 mV!
SecurityMode: Customer

info:

Get Info...
MobileMode: Service
HWID: 194 (SX1)
SX1 lg44 Sw12 23.04.04 08:59:17
IMEI: 352079001391547
DisplayID: 0, Unknown or misses
FSN: 21E72CAB
SW FlashID: 0089/8854 (0090/0090)
Code(05): OTP closed
Code(09): BootKEY is written in EEPROM
Code(0C): Keys miss in BCORE (CleanBCORE)
Code(13): Complete access to BFB
Code(15): Complete condition
Code(1A): Block 76 is accessible
Code(1C): Block 5123 is not found
Battery Voltage very low! 2198 mV!
SecurityMode: Factory
DSP Firmware Version 09, Power Asic Project ID: B3, RF Chipset ID: 05
EELITE Info: free buffer 54360 bytes, free at all 55622 bytes, free for deleted 55622 bytes.
EEFULL Info: free buffer 14374 bytes, free at all 35424 bytes, free for deleted 27376 bytes.
Battery Ri measurement: CutOff Idle: 3462mV, CutOff Talk: 3512mV, CutOff Idle: 3374mV, CutOff Talk: 3466mV, CutOff Idle: 3454mV, CutOff Talk: 3512mV, CutOff Idle: 3469mV, CutOff Talk: 3569mV.
Operating time: Total 15254880 sec, Current SW 15254880 sec.
Talk time: Total 31932 sec, Current SW 31932 sec.
CSD: Total 3861 bytes, Current SW 3861 bytes.
GPRS: Total 4294967295 bytes, Current SW 0 bytes.

[prihlaseny]

hlaska po recal keys:

Loading BootsModel(SX1)...
Sending StartBoot Ok.
Sending MainBoot Ok.
Com4 921600 BAUD: Ok.
Warning: HASH data error!
SIEMENS SX1 lg44 Sw12
Soft FlashID: 0089/8854 (0090/0090)
FlashID: 0089/8854
Flash Size: 8Mb
Region(1): Blocks 127, Size 64Kb
Region(2): Blocks 8, Size 8Kb
Start EEPROM segments at addres 0xFE0000
FSN: 21E72CAB -> PhoneID: AB2CE721
OTP IMEI: 352079001391547
HASH: FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
Use OTP IMEI: 352079001391547
USE SKEY: 12345678
*#0000*12345678# - Network Lock
*#0001*12345678# - Service Provider Lock
*#0002*12345678# - Corporate Code
*#0003*12345678# - Phone Code
*#0004*12345678# - Network Subset Lock
*#0005*12345678# - Only Sim
Read BCORE addr: 0x800000 size: 0x020000...
BCORE Clean! Use Freeze!
Read EEPROM addr: 0xFE0000 size: 0x020000...
EEPROM backup in ".\Backup\SX1lg44Sw12_EEPROM_060629092759.bin" file.
Write EEPROM addr: 0xFE0000 size: 0x020000...
Change BOOTKEY - Ok.
Change EEP0076 - Ok.
Change EEP5009 - Ok.
Change EEP5077 - Ok.
Change EEP5121 - Ok.
Change EEP5122 - Ok.
Change EEP5123 - Ok.

[Mio]

Dable nedelal bych to touhle rychlosti, bezpecnejsi je 57600


Jinak HASH mi pride prinejmesim podezrele. vzhledem k tomu ze hazi pri nacitani chybu.

Myslim ze sis svou aktivitou ten telefon dostal do daleko horsiho stavu, proc si sakra delal recall keys??

Udelej Freeze a pak zopakni prepocet klicu. (pri rychlosti 57600)

Pak odeber TP a dej tam novy FW winswup.

[prihlaseny]

jak mam odobrat TP? ten som spojil, a uz ide stale, v jokerovi nacita stale ho, jak to mam odobrat, nechapem, prilozil som len odpor, a spravil TP, ziaden pevny TP tam nieje

[Mio]