SiemensMania.cz

primozb2005 · Posted: Sun Jul 30, 2006 11:25 am Post subject: siemens sx1 dead....help

Hello

I have a big problem with my phone . My siemens sx1 wont turn on. I see some changes on monitor for 1 sekund. Embarassed

I trued to format him, but is not going. I connect him wit usb data cable to computer. Wenn a start the program hi send message (the phone is not connected). I tride ......but no more hope.

Please help.

Thanks
Primoz

Xmax88 · Posted: Sun Jul 30, 2006 11:38 am Post subject:

cabel DCA-510 - services and testpoint.

I not more help you Brick wall

primozb2005 · Posted: Sun Jul 30, 2006 12:26 pm Post subject:

??? testpoints. I found some pictures from testpoints. Shud i break the connection near the processor.

Xmax88 · Posted: Sun Jul 30, 2006 1:18 pm Post subject:

please wait on help somebody moderators
They are more practice Think

Mio · Posted: Sun Jul 30, 2006 1:30 pm Post subject:

Slow down. Testpoint is not right solution this time.

1st step:
Recharge your batery in another phone, or by shortcutting cherger pins and battery pins, 1st (left) on charger is +, second is GND, on batterry is written. Shortcutt + with + and GND with GND for 30 minutes

2nd step:
Try to Power on in SWUP mode (pressing joy when press red button)

If SWUP mode works, connect phone to PC using original USB cable (DCA-540) and install in Windows with USB SX1 driver - swup mod (is here http://www.siemensmania.cz/drivery.php?page=3)

And use winswup firmware update FW15 to flash. In winswup settings has to be checked USB only.

I SWUP mode does not work, you need service cable for Siemens x55 to x75, original from siemens is DCA-510.

Connect it to PC, install drivers from CD, connect mobile, run Winswup FW15, go in winswup settings, choose COM port where cable is installed, select speed 115200, close settings, select only fist part, click start and pres red button shortly. If succesfull, try run SWUP mod